Solved: J-Flash ARM: PC of target system has unexpected value after …
While erasing/programming the NOR Flash of min2440, I find J-Flash ARM resists responding:
PC of target system has unexpected value after …
To solve this problem, go to
Options -> Projection settings -> CPU -> Use following init sequence ->
find Item0, set Action from Reset to Halt
Done!
Click to enlarge
版权声明
本文出自 Lesca 技术宅，转载时请注明出处及相应链接。
本文永久链接: https://www.lesca.cn/archives/solved-j-flash-arm-pc-of-target-system-has-unexpected-value-after.html
crifan
2011-08-06 at 12:32
我也遇到同样问题了，不过是把reset的delay从0改为2ms，也解决问题了。